Home / Die casting and machining Die casting and machining

See the press that will cost you next week.

Shots, bands, oil, shot end, jet-cool and scrap, then tool load and leak test downstream. Every finding below is from a die-casting plant running Artekis, and you can open them yourself.

The evidence

What the finding shows

In one day the metal ran too cold for about 5 hours. Usually it is about 20 minutes.Gap of DCM-204 metal temperature to its setpoint, each running 5-minute step, latest 24 hoursInside the shaded range (target ±5 °F) is good. The temperature never went far enough to trip a warning limit, so nothing alarmed, but it kept sliding below the range. Artekis first flagged it on Nov 7.
-15-10-50+5Metal temperature compared with its target (°F). 0 is right on target.5 PM, Nov 89 PM1 AM, Nov 95 AM9 AM1 PMGood range: target ±5 °FToo cold for about 5 hours in a day. Usually about 20 minutes.The bars along the bottom mark the time it ran too cold. No alarm fired.-15-10-50+5Degrees from target temperature (°F)5 PM, Nov 85 AM, Nov 9Good range: target ±5 °FToo cold forabout 5 hours.Usually about 20 minutes.

Chart redrawn from the finding as Artekis showed it on Nov 9, 2026. Open the real finding

One Artekis finding for press DCM-302: what was found, why it matters, what to do now, how to prevent it, and the evidence table
Why press 302 stopped: jet-cool flow fell from about 3.9 to 2.5 gpm while the die ran hotter, the plant’s own procedure for what to check first, and every piece of evidence behind it.
The Anomaly Watch review queue: two drift cards for press DCM-304 intensifier response, each with its trend and Real issue, Not an issue and Known buttons
Press 304’s intensifier response drifting as its shot sleeve wore: each card has the trend, the span shaded, the figures and one-click verdicts.
From a line stop to the likely cause1:15Press DCM-202 stops. About a minute later, the likely cause and what to check first, from the plant’s own procedure, are on that press’s screen, with the evidence behind them. It works the same when an alarm goes off.
What your alarms say about themselves0:56A safety guard bypassed for three weeks, six in ten alarms marked High, a cooling tower alarm that chatters. Alarm Health finds each one and writes the fix.

Try it on a running die-casting plant

Whitfield Die Casting runs Artekis around the clock: twelve presses, two melters and three machining cells. Open the plant, click press DCM-204, and press Ask. No sign-in, on a computer or a phone; visitors share a daily allowance of questions.

Open the plant →
Next step

Tell us about your gateway and what you want to find out.

A member of our team reads every message and replies, usually the same day.

Contact us →